Opening The Front And Rear Cover Doors; Removal Of The Top Cover - Barco XDL Installation Manual

Removal and installation of the projector covers

7.1 Opening the front and rear cover doors

This procedure assumes that the lens is removed and that the hoses are disconnected from the
projector. This procedure is applicable for all four cover doors.
To access the thumbscrews of the top cover it is sufficient to open de cover doors a few
centimeters. In this case it's not needed to remove the lens and to disconnect the hoses.
Required tools
No tools required.
Open cover doors
1. Unlatch (reference 1
1
Image 7–1

7.2 Removal of the top cover

The illustrations in this procedure are based on the top-left cover. Nevertheless, the same
procedure is applicable for the top-right cover as well.
Required tools
Flat screwdriver 7 mm
How to remove a top cover?
1. Unlatch and pivot the front and rear plastic cover doors a few centimeters. This to gain access to the two
thumbscrews of the top cover. See procedure
2. Loosen the two captive thumbscrews of the top cover (reference 2
76 R5906150 /05 XDL
Image 7–1) and pivot the plastic cover door.
"Opening the front and rear cover doors", page
1
Image 7–2).
76.