Lens Removal; Displaying And Programming Addresses Into The Rcu - Barco XDL Installation Manual

Image 5–27

5.13 Lens removal

How to remove a lens from the Lens Holder?
1. Support the lens with one hand while you unlock the lens holder by sliding the lock handle (reference 1
Image 5–28) towards the "unlocked" position as illustrated.
2. Gently pull the lens out of the lens holder, maintaining its coaxial direction.
1
Image 5–28
It's recommended to place the Lens caps of the original Lens packaging, back on both sides of the
removed Lens to protect the optics of the Lens.
It's recommended to place the plastic cover of the original projector packaging, back into the lens
opening to prevent intrusion of dust. This plastic cover prevents that dust is entering the projector.
5.14 Displaying and Programming addresses into
the RCU
Displaying the Projector Address on the Screen.
1. If the projector is on, press the menu key and navigate to the Status page. The projector address and the
broadcast address can be seen under the Communication heading.
The projector's address is displayed on the LCD status screen and / or the OSD.
Installation procedures
R5906150 /05 XDL 61