Removal Of An Input Board - Barco XDL Installation Manual

Image 5–32
4. Tighten the captive screws of the input module.
Image 5–33
5. Plug in the power cord of the projector.
6. IMPORTANT LAST STEP — Update the firmware of the installed module. Use the complete software
package to install the firmware via Projector Toolset or USB stick.
Tip: When a complete new software image is placed on the projector, all programmable
components will be updated with the latest version.

5.19 Removal of an input board

WARNING: The procedures below may only be performed by Barco trained and qualified
technicians.
CAUTION: Always wear a wrist band which is connected to the ground while handling the
electrostatic discharge (ESD) sensitive parts.
The procedure below is applicable to all the input modules of the Input & Communication Unit of the
projector.
Required tools
• Phillips screwdriver PH1
• Torx screwdriver T10
How to remove
1. Switch off the projector and unplug the power cord of the projector.
3
Installation procedures
R5906150 /05 XDL 65