Table of Contents
Advertisement
Installation procedures
How to Program an Address into the RCU?
1.
Press the Address button until the Button pressed indicator lights up continuously (proximately 5
seconds).
2.
Enter the address with the digit buttons within the time the indicator lights up (also proximately 5 seconds).
Note: That address can be any value between 0 and 31.
Tip: A few examples:
To enter address 3, press "3" digit button on the RCU to set the RCU's address to 3 and wait
until the button pressed indicator is out. Alternatively, you can also press "0" and "3". This way,
the button pressed indicator goes out immediately.
To enter address 31, then press "3" and "1" on the digit button on the RCU and the button
pressed indicator goes out immediately.
5.15 Using the XLR connector of the RCU
Connecting a cable with the XLR connector will reset the broadcast address of the RCU to its
default value '0'.
How to use the XLR connector
1.
Remove the XLR cover by pulling it backwards.
Image 5–29
2.
Connect a cable with XLR plug into the XLR connector of the RCU.
3.
Connect the other end of the cable with the XLR input of the projector.
Note: While the XLR cable is connected, the IR beam of the RCU is switched off.
5.16 Setting the projector addresses
Projector address
Address installed in the projector to be individually controlled via the RCU or via the serial
communication.
Broadcast address
Projector will always execute the command coming from a RCU programmed with that broadcast
address.
62
R5906150 /05
XDL
Advertisement
Table of Contents
