Power Loop Through To The Projector Electronics - Barco XDL Installation Manual

Image 5–16
4. Secure the AC power supply cord by fastening the cable gland (reference 2
5. Install the cover of the mains compartment.

5.9 Power loop through to the projector electronics

This procedure explains how to provide the projector electronics with power in case no UPS unit is
used. Note that the projector is by default configured for use without UPS. So, the short power link
cable is already installed.
Required tools
No tools required.
Required parts
Short power link cable with plug type C13/C14
How to loop through the power?
1. Plug in the short power cable (reference 1
Warning: Always use the Barco short power cable which is delivered with the projector.
2. Secure both plugs of the short cable with a fixation spring (reference 2
• Squeeze the fixation spring together.
• Slide the fixation spring on the fixation pins (reference 3
push it against the power plug.
• Release the fixation spring.
1
L1 L1 L1 L1
2
Image 5–17) which was delivered with the projector.
Installation procedures
L2 L2 L2 L2 L3 L3 L3 N N PE
PE PE PE PE
Image 5–16).
Image 5–17). Handle as follow:
Image 5–17) while squeezing together and
R5906150 /05 XDL 55