Table of Contents
Advertisement
How to shift the Lens Holder?
1.
Open the projector front cover. See
2.
Loosen the 4 screws (1) until the central part of the Lens Holder becomes loose. Use a 3 mm Allen
wrench.
3.
Shift the central part up or down as desired. The lowermost, middle and uppermost shift positions are
marked on the Lens Holder with a little arrow (2).
4.
Tighten the 4 screws (1) to a torque of 8.4 Nm.
2
Image 4–9
5.
Close the front projector cover again.
4.6 Available lenses
Which lenses are available for my projector?
The table below is subject to changes and was last updated on 20/02/2018. Consult Barco's web
site for the most recent information about available lenses.
Order No
R9852945
R9852950
R9852090
R9852092
R9852094
R9852100
R9852920
R9856506
R9856294
R9856297
"Opening the front and rear cover doors", page
1
2
Type
XLD
XLD
XLD
XLD
XLD
XLD
XLD
HB
HB
HB
Installation preparations
76.
Throw Range (4K)
0.75
1.0
1.45 - 1.8
1.8 - 2.4
2.2 - 3
2.8 - 5.5
5.5 - 8.5
1.13 - 1.72
1.35 - 1.86
1.46 - 2.10
R5906150 /05
XDL
41
Advertisement
Table of Contents
