Connecting The External Safety Interlocks - Barco XDL Installation Manual

Image 5–10
6. Loosen the retaining screw (reference 3
Use a 3 mm Allen wrench.
7. Pivot the inner front door to have full access the mains compartment parts.
Image 5–11

5.6 Connecting the external safety interlocks

The terminal for the external safety interlocks is located inside the mains compartment. This
procedure assumes that the cover of the mains compartment is already removed. See chapter
"Accessing the mains compartment", page
Required tools
Flat screwdriver (small)
How to connect the external safety interlocks with the projector?
1. Remove the 10 pole terminal block from its socket (reference 3
2. Guide the cable(s) coming from the external interlock device(s) through the cable gland(s) located at the
base of the mains compartment (reference 4
3. Remove the shunt wire(s) from the 10 pole terminal block and connect the cable(s) according the
schematic in Image 5–12.
Image 5–11) of the inner front door (door with the Stop button).
50.
Image
Image 5–12).
Installation procedures
5–12). Use a small screw driver.
R5906150 /05 XDL 51