Removing The Transport Protection Bars - Barco XDL Installation Manual

CAUTION: Replace with the correct battery type. Use two AA size batteries. There is a risk of
explosion if the battery is replaced with an incorrect type.
CAUTION: Replace the battery as explained above. There is a risk of explosion if the battery is
incorrectly installed.

5.2 Removing the transport protection bars

What needs to be done?
After the projector is unpacked and placed on its pedestal the transport protection bars at the front and at the
rear of the projector have to be removed.
The transport protection bars need to be removed to connect the hoses of the cooling system with
the projector and to have easy access to the dust filter at the front side.
Required tools
Allen wrench 10 mm
How to remove the transport protection bars?
1. Remove the two fixation screws (reference 1
a 10 mm Allen wrench.
Image 5–4
2. Pull the transport protection bar out of its slot.
1
Image 5–5
3. Repeat these steps to remove the other transport protection bar as well.
Image 5–4) in the center of the transport protection bar. Use
1
Installation procedures
R5906150 /05 XDL 47