Husqvarna FC 250 2016 Repair Manual page 184

17 ENGINE
182
O
-
Press in shaft seal ring
side facing out so it is flush.
-
Mount and tighten nozzle@.
Guideline
Nozzle, crank M4
chamber venti-
lation
-
Mount and tighten oil nozzle
Guideline
Oil nozzle for M4
conrod bearing
lubrication
-
Mount the oil nozzle for piston cooling.
-
Mount and tighten screw
Guideline
Screw, oil noz- M4
zle for piston
cooling
-
Position all bearing locks.
-
Mount and tighten screws Ci).
Guideline
Locking screw M5
for bearing
-
Blow out the oil channel with compressed air and check that
it is clear.
of the crankshaft with the open
2 Nm (1.5 lbf ft)
Loctite ®
@).
2 Nm (1.5 lbf ft)
®
Loctite
C,.
2 Nm (1.5 lbf ft)
®
Loctite
6 Nm (4.4 lbf ft)
Loctite ®
243
™
243
™
243
™
243
™
•