Changing The Engine Oil And Oil Filter, Cleaning The Oil Screen - Husqvarna FC 250 2016 Repair Manual

Changing the engine oil and oil filter, cleaning the oil screen

Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
-
Wear suitable protective clothing and safety gloves.
-
In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Hazardous substances cause environmental damage.
Environmental hazard
-
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Check the O-rings for damage.
Replace damaged O-rings.
Drain the engine oil while the engine is at operating temperature.
20 LUBRICATION SYSTEM
Condition
The engine is cold.
-
Check the engine oil level.
e.
The engine oil reaches the middle of level
viewer
If the engine oil does not reach the middle of the level
viewer:
-
Add engine oil.
Condition
The engine is at operating temperature.
-
Check the engine oil level.
Info
After switching off the engine, wait one minute
before checking the level.
The engine oil level is between the middle of the
level viewer f) and the upper edge of the level
viewer G).
If the engine oil does not reach the middle of level
viewer f):
-
Add engine oil.
Preparatory work
-
Park the motorcycle on a level surface.
(I!!:! p. 246)
(� p. 246)
..
243