Husqvarna FC 250 2016 Repair Manual page 100

12 FUEL TANK, SEAT, TRIM
98
Main work
-
Check the throttle cable routing.
-
Position the fuel tank and fit the two spoilers to the sides of
the radiator bracket.
-
Make sure that no cables or throttle cables are trapped or
damaged.
-
Attach the hose to the fuel tank breather on the tank lid.
-
Mount and tighten screw
Guideline
Remaining screws,
chassis
-
Mount and tighten screws
Guideline
Remaining screws,
chassis
(D
-
Plug in connector for the fuel pump.
-
Remove the wash cap set and thoroughly clean the plug-in
connection of the fuel line using compressed air.
Info
Under no circumstances should dirt enter into the fuel
line. Dirt in the fuel line clogs the injection valve!
-
Lubricate the 0-ring and connect plug-in connection
the fuel line.
Info
Route the cable and fuel line at a safe distance from
the exhaust system.
Finishing work
-
Mount the seat. (llill p. 95 )
-
Install the air filter box cover.
-
Install the right side cover.
(llill p. 43)
O
with the rubber bushing.
M6 10 Nm (7.4 lbf ft)
8.
M6 10 Nm (7.4 lbf ft)
(llill p. 90)
(llill p. 94)
8
for