Cartridge, Assembling - Husqvarna FC 250 2016 Repair Manual

cartridge, assembling

Info
The procedures are the same on both fork legs.
I
8
R00029-11
R00028-11
Preparatory work
-
Assemble the seal ring retainer.
-
Assemble the piston rod.
Main work
-
Mount and grease seal rings
I
Lubricant (T158) (!!:! p. 282)
-
Mount and lubricate pilot bushings (D.
I
Fork oil (SAE 4) (48601166S1)
-
Check the length of the reservoir spring.
Guideline
Reservoir spring length with
preload spacer
If the length is out of tolerance:
-
Correct the preload spacers.
-
Position the spring with the preload spacers in the reservoir.
C,
-
Position sleeve in the reservoir.
-
Clamp cartridge with special tool.
I
Clamping stand (T14049S)
0
-
Slide reservoir onto the cartridge.
Info
Hold the sleeve in the reservoir to prevent it from slid­
ing out.
-
Mount lock ring (D.
-
Mount seal ring retainer @ with the washer and tighten.
Guideline
Seal ring M23.5x0.75
retainer
-
Unclamp the cartridge.
6 FORK, TRIPLE CLAMP
(!,JI p. 26)
(!,JI p. 27)
O 8.
and O-ring
(� p. 280)
46 mm (1.81 in)
(!,JI p. 299)
46 Nm (33.9 lbf ft)
®
Loctite 2701
TM
29