Hydraulic Control Settings - Raven SC1 Calibration And Operation Manual

HYDRAULIC CONTROL SETTINGS

FIGURE 12. Hydraulic Control Setup Screen
To access implement control settings:
1. From the SC1/TC1 Home screen, select the Tools Menu button.
2. Select the Steering Setup tab and the Implement Control Settings button. The following information and
settings are displayed on the page:
NOTE: Select the Help
• Velocity - The speed at which the implement steering actuator is moving, measured in voltage per second.
• Control Effort - The amount of effort the SC1/TC1 system is using to drive the implement steering actuator.
• Valve/Motor Current - Displays the current draw of the steering valve.
• Left/Right MIN/MAX - Touch and hold the MIN or MAX button to test the steering system response using the
set minimum and maximum values. For example, touching the Left MIN button will steer the machine to the
left using the minimum control effort.
• Left/Right Min % - Set the Min % to the minimum value required to move the implement steering actuator.
NOTE: The Min values cannot exceed the Max values.
• Left/Right Max % - The Max% value can be used to limit the maximum speed of the implement steering
actuator, if desired.
3. Select the Accept button in the lower, right corner of the screen to save the displayed settings and return to the
Steering Setup tab.
Implement Settings and Tuning: Steering Setup Tab
icon for more information about the settings shown on the screen.
IMPLEMENT SETTINGS AND TUNING
39