Front Turn Signal , Number Plate Light Rear Lights. Interior Light - Volkswagen Transporter Instruction Manual

• Fit cap properly - it must contact the re­
flector - and attach connector.
• Install headlight.
• Have alignment checked.
Side light bulb (Normal and halogen head­
lights)
• Remove headlights as described on pre ­
vious page.
• Take headlight rim off and remove
with headlight (as explained on previous
page).
• Turn bulb holder to the left and take it out
of reflector.
• Turn bulb to left and take it out. Ensure
that bulb designations tally.
• Press new bulb into holder and turn it to
the right.
• Press holder into reflector and turn bulb to
the right.
• Install headlight
• Have alignment checked.
It is always advisable to carry a box of spare
bulbs in the car. TAese can be obtained from
any VAG workshop.
Sealed-Beam headlights
(Export models only)
Seven inch units with twin filaments are
used.
• Remove screw in trim ring and take ring
off.
• Remove three short screws in the retain ­
ing ring and take ring off.
Caution! Do not alter the setting of the
three long screws.
• Take Sealed-Beam unit out and Dull ca ­
ble connector off.
• When installing the new unit, ensure that
the lugs engage properly in the support.
• Screw trim ring securing screw in 2 or 3
turns.
• Press opposite side of trim ring over the
metal lug on the edge of the headlight re ­
cess and then tighten screw.
If no other parts of the headlight have been
altered. the headlight alignment will not have
changed.
Rear lights
• Remove lens.
• Press defective bulb into holder. turn to
left and take out.
Do-it-yourself
Bulb positions:
Top Turn signal light
Centre - Brake/tail light
Bottom - Back-up light
• When installing a twin-filament brake/tail
light bulb, the pin nearest to glass must be
downwards.
• Install lens.
• Tighten screws uniformlv but do not over ­
tighten.
Front turn signal and license plate lights
• Remove lens.
• Press defective bulb into holder, turn to
left and take out.
• Fit new bulb.
• Check that seal is located properly and do
not overtighten lens securing screws.
Interior light
• Place screwdriver carefully between
housing edge and headlining and lever
light out.
• Take bulb out.
• Install new bulb.
• Insert retaining lug first and then press
lamp in until spring engages.
61