Download  Print this page


D O - I T - Y O U R S E L F
Number plate light
"he number plate lights are pushed into
:ne cross panel from the rear.
Press lugs together and pull light
-.ousing out to the rear.
Remove lens.
Press bulb into holder, turn it to the
eft and renew it.
Install lens.
Ensure that the lug in the lens engages
:he opening in the bulb-holder as other-
wise the number plate will not be illumi-
nated properly.
Do not overlighten lens screws.
Install light again. Ensure that housing
fits over the metal tab at the top and en-
gages the hole in cross panel at the front.
Interior light
Press retaining spring at opposite
end to switch inwards and take light out.
Renew bulb.
Insert light at switch end first.
Reading lamps*
Lever adjusting ring out at side recess
with flat blade of screwdriver.
Press bulb into fitting slightly, turn it
to right and take it out.
Install new bulb.
Fit adjusting ring so that recesses in
ring are in line with those on lamp hous-
Press adjusting ring on.
Table light*
Push flat screwdriver blade behind
light housing on left so that the spring
behind it is pushed to one side and then
lever housing off.
Pull reflector out.
Change bulb.
Insert reflector again.
Push lug on right of lamp housing
behind trim on right first and then press
light on.
Interior light in front of passenger
seat, step light, boot lights.*
Lever glass out at side with flat screw-
driver blade.
Change bulb.
Press glass into the trim again. - a useful website for owners and enthusiasts of VW Westfalia T25 / T3 / Vanagon Campervans


This manual also for:


Comments to this Manuals

Symbols: 0
Latest comments: