Snap-On PRO-LINK EDGE Hardware User Manual page 87

The list of datapoints is displayed, showing the new value.
Figure 4.26
List of Datapoints for the Cruise Control Category
5
To complete the calibration, and accept the new value, touch the Program
button.
If you choose not to program the calibration at this time, you can continue to
make additional calibrations, and then program all of your calibrations at the
same time. If you attempt to leave the CALS tab, a message is displayed
reminding you that there are unprogrammed calibrations and warning you
that they will be lost if you continue.
The Program feature is not universally used across all vehicle applica-
tions. Some tests will employ the Program feature, others will not.
NOTE:
i
In the event that you are prompted to enter a password or passwords,
follow the prompts. The PRO-LINK
enter the password, if required, for you.
If you touched Program, the final step in the calibration process begins.
6
When prompted, turn OFF the ignition.
7
When prompted, turn ON the ignition.
®
Edge in most cases will automatically
®
PRO-LINK Edge Hardware and Software User's Manual
- The Diagnostics Menu
83