Chapter 3: Getting Started; Supplying Power To The Pro-Link® Edge - Snap-On PRO-LINK EDGE Hardware User Manual

Chapter
• Getting Started
3
Supplying Power to the PRO-LINK
There are three ways to supply power to the PRO-LINK
i
i
To turn on the PRO-LINK
front of the device. To turn it off, hold down the On/Off switch for approximately
four (4) seconds, or until the display goes blank.
®
30 PRO-LINK Edge Hardware and Software User's Manual
• On-board battery—A 10.8 volt, 3.2 AH Li-ion battery is included with
your device.
®
The PRO-LINK Edge on-board battery is recharged when:
— The device is turned on and the AC/DC Power Adapter is being used
— The device is turned off and plugged into the AC/DC Power Adapter
— The device is plugged into the vehicle datalink connector
NOTE:
For more information on monitoring battery power, refer to Monitoring Bat-
tery Power on page 53 of this guide.
• AC/DC power adapter—If you do not wish to use the battery, or the bat-
tery power is low, you can use the AC/DC Power adapter to supply
power to the device.
• Vehicle itself—In most vehicles, you can use the vehicle's datalink
adapter to supply power to the PRO-LINK
NOTE:
The device will automatically go into Standby Mode after 10 minutes. To
exit Standby mode, tap the screen. After 1 hour of user inactivity, the PRO-
®
LINK Edge will power off.
®
Edge, press and briefly hold the On/Off switch on the
®
Edge
®
Edge. You can use the:
®
Edge.