Installing a NetIron XMR 8000 router
FIGURE 104 Installing a module in a NetIron XMR 8000 router
NOTE
When inserting the module into the router, make sure that the faceplate doesn't overlap with the faceplate of an adjacent
interface module.
4.
Rotate the ejectors flush with the module faceplate to fully seat the module in the backplane. Modules have a snug fit for
maximum EMI protection.
5.
Tighten the two screws at each end of the module faceplate by pushing them in and turning them clockwise. Complete the
tightening process using the flat-blade screwdriver.
Installing NetIron XMR 8000 router power supplies
Follow these steps to install a power supply in the NetIron XMR 8000 router.
1.
Remove the power supply slot blank.
2.
Remove the power supply from the packaging.
3.
Insert the power supply into the slot, using the guides provided on either side of the slot.
Carefully follow the mechanical guides on each side of the power supply slot and make sure the power
supply is properly inserted in the guides. Never insert the power supply upside down.
148
Brocade MLX Series and Brocade NetIron XMR Installation Guide
53-1004195-02