Replacing A Management Module; Installing The Compact Flash Card In An Mr2 Management Module - Brocade Communications Systems MLX Series Installation Manual

Replacing a management module

Replacing a management module
For instructions on how to install or replace modules, refer to the module installation section in the installation chapter for your router
model.

Installing the Compact Flash Card in an MR2 management module

MR2 management modules allow users to insert an additional 2 Gbps compact flash card. To install the card, you need a flat head or
Philips screw driver. Refer to
NOTE
MR and MR2 management modules should not be used together in the same chassis.
Please read the Hardware Installation Notes that came with your hardware before installing the MR2 management module.
The internal compact flash card cannot be accessed for removal or replacement.
To obtain a replacement or a new compact flash card, contact Brocade technical support.
To install a compact flash card in an MR2 management module:
1. Remove the two screws holding the compact flash card cover in place using a flat head or Phillips screw driver.
Put the screws and cover plate aside; you will need to reattach the cover using the screws after installing the card.
2. Slide the compact flash card into the slot.
3. Reattach the cover plate using the two screws and screwdriver.
250
Figure 153 to see where the slot card should be placed.
Brocade MLX Series and Brocade NetIron XMR Installation Guide
53-1004195-02