Installing Netiron Xmr 4000 Modules - Brocade Communications Systems MLX Series Installation Manual

Installing a NetIron XMR 4000 router
FIGURE 95 Mounting the NetIron XMR 4000 router in a rack (front-mount configuration)
1 Standard 19 inch rack
4. Slide the router down so that the screw heads are in the narrow portion of the keyhole slots.
5. Tighten the screws to secure the router.
NOTE
To provide better grounding of the router to the rack, use star washers to attach the router. You can also use star washers with any
single-hole grounding lugs to prevent rotation of the lug.
6. Add additional screws as needed.
7. Repeat step 2 through

Installing NetIron XMR 4000 modules

The NetIron XMR 4000 router ships with the required switch fabric modules installed.
The installation procedure in this section applies to all modules. The sequence for installing multiple modules is important to ensure
proper fit. The recommended sequence for the NetIron XMR 4000 router is to start with the lowest row, then move upwards from
right-to-left.
For instructions about installing 2x100GbE interface modules, refer to
page 130.
The intra-building port or ports of the equipment or subassembly is suitable for connection to
intra-building or unexposed wiring or cabling only. The intra-building port or ports of the equipment or
subassembly MUST NOT be metallically connected to interfaces that connect to the outside plant (OSP) or
its wiring. These interfaces are designed for use as intra-building interfaces only (Type 2 or Type 4 ports
136
step 6 to mount each subsequent router in the same rack.
1
2
"Installing 2x100GbE interface modules in NetIron XMR routers"
Brocade MLX Series and Brocade NetIron XMR Installation Guide
on
53-1004195-02