Installing A Netiron Xmr Router; Installation Precautions; General Precautions - Brocade Communications Systems MLX Series Installation Manual

Installing a NetIron XMR Router

This chapter describes how to install a NetIron XMR router and its modules in the following sections:
•

"Installation precautions"

•
"Installing 2x100GbE interface modules in NetIron XMR routers"
•
"Installing a NetIron XMR 4000 router"
•
"Installing a NetIron XMR 8000 router"
•
"Installing a NetIron XMR 16000 router"
•
"Installing a NetIron XMR 32000 router"
•
"Attaching a management station"
•
"Activating the power source"
•
"Verifying proper operation"
The illustrations in this chapter display how to correctly insert the modules and routers. For a complete router module description and slot
number identification, refer to
NOTE
Illustrations in this chapter may differ slightly from the actual equipment.
Installation precautions
Before proceeding, please read all cautions and danger notices for installing NetIron XMR routers.

General precautions

Follow these general precautions when installing a NetIron XMR router.
The procedures in this manual are for qualified service personnel.
If the installation requires a different power cord than the one supplied with the router, make sure you
use a power cord displaying the mark of the safety agency that defines the regulations for power cords in
your country. The mark is your assurance that the power cord can be used safely with the router.
All fiber-optic interfaces use Class 1 Lasers.
Brocade MLX Series and Brocade NetIron XMR Installation Guide
53-1004195-02
on page 127
on page 133
on page 142
on page 152
on page 162
on page 184
on page 185
on page 186
"NetIron XMR routers" on page 6 of this guide.
on page 130
127