Default Scsi Ids - HP Visualize b160L Supplementary Manual

Chap3.doc 34 Thu Jul 25 10:23:22 1996
NOTE:
Table 6
NOTICE:
Configuration
FRU Configurations
Table 6 lists the recommended SCSI IDs for internal
storage devices.
There are no jumper settings to change for the floppy drive.
These SCSI IDs are the default IDs for each storage
device. If an existing device already uses an ID, select
an alternate ID.

Default SCSI IDs

Fast, Wide SCSI
1st Hard Disk Drive
2nd Hard Disk Drive
Note: The Fast, Wide SCSI controller is set to
SCSI ID 7.
Single-Ended SCSI
CD-ROM Drive
DDS Drive
1st Hard Disk Drive
2nd Hard Disk Drive
Notes: The floppy drive is NOT a SCSI device.
The SCSI controller is set to SCSI ID 7.
The floppy disk drive is not a SCSI device.
The following figures show the CD-ROM and DDS
tape drive SCSI address and jumper settings. For
jumper settings for other types of drives, refer to the
label on your hard drive for specific jumper informa-
tion for that device.
34
ID 6
ID 5
ID 2
ID 3
ID 6
ID 5