Selecting Device Address
Procedure
1
Unpack the device.
2
Set only jumpers or switches that are required to change the device SCSI address, any
others should remain as shipped.
The default SCSI addresses for devices is shown in Table 5-6. You should check the
address as set on the failing drive and set the address on the new drive to the same
value.
Table 5-6
Removing and Replacing Mass Storage Devices
Default SCSI Addressing
1st Hard Disk Drive
2nd Hard Disk Drive
3rd Hard Disk Drive
DDS Drive
CD-ROM Drive
Floppy Drive
ID 6
ID 5
ID 4
ID 3
ID 2
ID 0
5-17