HP Visualize b160L Supplementary Manual page 172

Service.book : Chap9.doc 179 Thu Jul 25 11:01:09 1996
Displaying and Setting the Monitor Type
To set the monitor type for graphics(0) to monitor type
2 you would enter the following;
Config Menu: Enter command>
The boot console displays a message that tells you that
your new monitor selection will take affect the next
time you reboot your system.
This will take effect on the next reboot.
MONITOR INFORMATION
Path Slot Head
----------- ---- ---- --------
GRAPHICS(0) 0 1 f8000000
The boot console also displays the new monitor infor-
mation.
Trying to change the monitor type to a number not
listed for that graphics device fails and gives you the
following warning message:
Value of monitor type n out of range (n - nn)
Trying to change the monitor type on an empty slot
fails and gives you the following warning message:
No such graphics card.
Boot Console Interface
monitor graphics(0) 2
HPA Resolution Freq Type
---------- ---- ----
1280x1024 72Hz
Class
-----
2
179