Service.book : Chap9.doc 171 Thu Jul 25 11:01:09 1996
Table 39
Path Type
primary or pri
alternate or alt
console or con
keyboard or key
Displaying and Setting Paths
A path is the hardware address of a device that is
attached to the I/O system of your workstation. The
path command sets the system paths shown in
Table 39.
The path command sets and displays the hardware
address of a specified device attached to the I/O bus of
your workstation.
System Paths
Your workstation's default boot device (usually the root
disk)
Your workstation's alternate boot device (usually a DDS-
format tape device)
Your workstation's primary display device
Your workstation's primary ASCII input device
To display the current settings for the system paths,
type the following at the prompt:
Main Menu: Enter command >
Boot Console Interface
Displaying and Setting Paths
Device
path
171