RAM 1500 CLASSIC 2020 Owner's Manual page 337

Answering An Incoming Call
Call Controls
The buttons on the display allow the following
phone call functions to be managed:
Answer

End

Ignore

Put on hold/resume

Deactivate/activate the microphone

Transfer the call

Switch from one call to the other

Conference/merge two active calls

Answering Or Ignoring A Call With No Call Currently
In Progress
When an incoming call rings or is announced on
the Uconnect system, push the Answer button on
the touchscreen, or push the PHONE button on the
steering wheel.
Answering Or Ignoring An Incoming Call With A Call
Currently In Progress
When an incoming call rings or is announced on
the Uconnect system, push the Answer button on
the touchscreen, or push the PHONE button on the
steering wheel to answer the call and put the
ongoing call on hold.
NOTE:
Not all mobile phones support the management of
an incoming call when another phone conversation
is active.
Managing Two Phone Calls
If two calls are in progress (one active and one on
hold), it is possible to switch between them by
pressing the Call On Hold button or to merge the
two calls into a conference call by pressing the
Merge Calls button.
NOTE:
Check whether the mobile phone in use supports
the management of a second call and the
"Conference" mode.
Transferring/Call Continuation
Transferring
The ongoing calls can be transferred from the
mobile phone to the system and vice versa without
ending the call.
To transfer the call, press the Transfer button.
Call Continuation
After the engine is switched off, it is still possible to
continue a phone call.
The call continues until it is ended manually or for
a maximum period of about 20 minutes.
When the system is switched off, the call is
transferred to the mobile phone.
MULTIMEDIA
Ending A Call
Press the End button on the touchscreen or the
PHONE button on the steering wheel controls to
end a call in progress.
Only the ongoing call is ended and any call on hold
becomes the new active call.
Depending on the type of mobile phone, if the
ongoing call is ended by the caller, the call on hold
may not be activated automatically.
Uconnect Phone Features
MUTE/UNMUTE
1. During a call, push the VOICE COMMAND
button on the steering wheel.
2. After the beep, say "mute" or "mute off".
READING MESSAGES
The system can read the messages received by the
mobile phone.
To use this function, the mobile phone must
support the SMS exchange function via
Bluetooth®.
335
9