Table of Contents
Advertisement
176
STARTING AND OPERATING
3. Turn the ignition to the OFF position. On
vehicles with Keyless Enter-N-Go, push and
hold the ignition switch until the engine turns
OFF.
4. Wait approximately 30 seconds.
5. Restart the engine.
6. Shift into the desired gear range. If the
problem is no longer detected, the
transmission will return to normal operation.
NOTE:
Even if the transmission can be reset, we
recommend that you visit an authorized dealer at
your earliest possible convenience. An authorized
dealer has diagnostic equipment to assess the
condition of your transmission.
If the transmission cannot be reset, authorized
dealer service is required.
Electronic Range Select (ERS) Operation
The Electronic Range Select (ERS) shift control
allows the driver to limit the highest available gear
when the transmission is in DRIVE. For example, if
you set the transmission gear limit to 4 (FOURTH
gear), the transmission will not shift above
FOURTH gear (except to prevent engine
overspeed), but will shift through the lower gears
normally.
You can switch between DRIVE and ERS mode at
any vehicle speed. When the transmission gear
selector is in DRIVE, the transmission will operate
automatically, shifting between all available gears.
Tapping the GEAR - switch (on the steering wheel)
will activate ERS mode, display the current gear in
the instrument cluster, and set that gear as the top
available gear. Once in ERS mode, tapping the
GEAR - or GEAR + switch will change the top
available gear.
1 — GEAR - Switch
2 — GEAR + Switch
To exit ERS mode, simply push and hold the GEAR +
switch until the gear limit display disappears from
the instrument cluster.
WARNING!
Do not downshift for additional engine braking
on a slippery surface. The drive wheels could
lose their grip and the vehicle could skid,
causing a collision or personal injury.
When to Use TOW/HAUL Mode
When driving in hilly areas, towing a trailer, carrying
a heavy load, etc., and frequent transmission
shifting occurs, push the TOW/HAUL switch to
activate TOW/HAUL mode. This will improve
performance and reduce the potential for
transmission overheating or failure due to
excessive shifting.
TOW/HAUL Switch
Advertisement
Table of Contents
