RAM 1500 CLASSIC 2020 Owner's Manual page 170

168 STARTING AND OPERATING
WARNING!
Driver inattention could lead to failure to place

the vehicle in PARK. ALWAYS DO A VISUAL
CHECK that your vehicle is in PARK by verifying
that a solid (not blinking) "P" is indicated in
the Instrument Cluster Display and near the
gear selector. If the "P" indicator is blinking,
your vehicle is not in PARK. As an added
precaution, always apply the parking brake
when exiting the vehicle.
AutoPark is a supplemental feature. It is not

designed to replace the need to shift your
vehicle into PARK. It is a backup system and
should not be relied upon as the primary
method by which the driver shifts the vehicle
into PARK.
If the vehicle is not in PARK and the driver turns off
the engine, the vehicle may AutoPark.
AutoPark will engage when all of these conditions
are met:
Vehicle is equipped with a rotary gear selector

and an 8-speed transmission
Vehicle is not in PARK

Vehicle speed is 1.2 mph (1.9 km/h) or less

Ignition switched from RUN to ACC

NOTE:
For Keyless Enter-N-Go equipped vehicles, the
engine will turn off and the ignition switch will
change to ACC mode. After 30 minutes the ignition
switches to OFF automatically, unless the driver
turns the ignition switch OFF.
If the vehicle is not in PARK and the driver exits the
vehicle with the engine running, the vehicle may
AutoPark.
AutoPark will engage when all of these conditions
are met:
Vehicle is equipped with a rotary gear selector

and an 8-speed transmission
Vehicle is not in PARK

Vehicle speed is 1.2 mph (1.9 km/h) or less

Driver's seat belt is unbuckled

Driver's door is ajar

Brake pedal is not depressed

The message "AutoPark Engaged Shift to P then
Shift to Gear" will display in the instrument cluster.
NOTE:
In some cases the ParkSense graphic will be
displayed in the instrument cluster, causing the
"AutoPark Engaged Shift to P then Shift to Gear" to
not be seen. In these cases, the gear selector must
be returned to "P" to select desired gear.
If the driver shifts into PARK while moving, the
vehicle may AutoPark.
AutoPark will engage ONLY when vehicle speed is
1.2 mph (1.9 km/h) or less.
The message "Vehicle Speed is Too High to Shift
to P" will be displayed in the instrument cluster if
vehicle speed is above 1.2 mph (1.9 km/h).
WARNING!
If vehicle speed is above 1.2 mph (1.9 km/h), the
transmission will default to NEUTRAL until the
vehicle speed drops below 1.2 mph (1.9 km/h). A
vehicle left in the NEUTRAL position can roll. As an
added precaution, always apply the parking brake
when exiting the vehicle.
4WD LOW — If Equipped
AutoPark will be disabled when operating the
vehicle in 4WD LOW.
The message "AutoPark Disabled" will be
displayed in the instrument cluster.
Additional customer warnings will be given when
all of these conditions are met:
Vehicle is not in PARK

Driver's door is ajar

Vehicle is in 4WD LOW range
