RAM 1500 CLASSIC 2020 Owner's Manual page 194

192 STARTING AND OPERATING
The ParkView Camera is located to the left of the
tailgate handle.
When the vehicle is shifted out of REVERSE (with
Camera delay turned off), the rear Camera mode is
exited and the navigation or audio screen appears
again.
When the vehicle is shifted out of REVERSE (with
Camera delay turned on), the rear Camera image
will be displayed for up to 10 seconds after shifting
out of REVERSE unless the forward vehicle speed
exceeds 8 mph (13 km/h), the transmission is
shifted into PARK or the ignition is placed in the
OFF position.
Whenever the Rear View Camera image is
activated through the "Backup Camera" button in
the "Controls" menu, a display timer for the image
is initiated. The image will continue to be displayed
until the display timer exceeds 10 seconds and the
vehicle speed is above 8 mph (13 km/h) or the
touchscreen button "X" to disable the display of the
Rear View Camera image is pressed.
NOTE:
If the vehicle speed remains below 8 mph
(13 km/h), the Rear View Camera image will be
displayed continuously until deactivated via the
touchscreen button "X".
A touchscreen button "X" to disable display of the
camera image is made available when the vehicle
is not in REVERSE gear.
When enabled, active guide lines are overlaid on
the image to illustrate the width of the vehicle and
its projected backup path based on the steering
wheel position. The active guide lines will show
separate zones that will help indicate the distance
to the rear of the vehicle.
NOTE:
For further information about how to access and
change the programmable features of the
ParkView Rear Backup Camera, refer to "Uconnect
Settings" in "Multimedia" for further information.
The following table shows the approximate
distances for each zone:
Distance To The Rear
Zones
Of The Vehicle
Red 0 - 1 ft (0 - 30 cm)
1 ft - 6.5 ft
Yellow
(30 cm - 2m)
6.5 ft or greater
Green
(2 m or greater)
WARNING!
Drivers must be careful when backing up even
when using the ParkView Rear Back Up Camera.
Always check carefully behind your vehicle, and
be sure to check for pedestrians, animals, other
vehicles, obstructions, or blind spots before
backing up. You are responsible for the safety of
your surroundings and must continue to pay
attention while backing up. Failure to do so can
result in serious injury or death.
CAUTION!
To avoid vehicle damage, ParkView should

only be used as a parking aid. The ParkView
camera is unable to view every obstacle or
object in your drive path.
To avoid vehicle damage, the vehicle must be

driven slowly when using ParkView to be able
to stop in time when an obstacle is seen. It is
recommended that the driver look frequently
over his/her shoulder when using ParkView.