Table of Contents
Advertisement
Regular Cab Trucks:
In the regular cab truck, the top tether anchorages
are located behind the center and right passenger
seats. There is a plastic cover over each
anchorage. To attach the tether strap of the child
restraint:
1. Place the child restraint on the seat and
adjust the tether strap so that it will reach
over the seat back, under the head restraint
and to the tether anchor directly behind the
seat.
Regular Cab Tether Anchorages
1 — Tether Strap Hook
2 — Tether Strap To Child Restraint
3 — Tether Anchor
2. Route the tether strap to provide the most
direct path between the anchorage and the
child seat. The tether strap should go between
the head restraint posts underneath the head
restraint. You may need to adjust the head
restraint to the upward position to pass the
tether strap underneath the head restraint
and between its posts.
3. Lift the cover (if so equipped), and attach the
hook to the square opening in the sheet metal.
Tighten the tether strap according to the child
seat manufacturer's instructions.
WARNING!
Never place a rear-facing child restraint in front
of an air bag. A deploying Passenger Front Air
Bag can cause death or serious injury to a child
12 years or younger, including a child in a
rear-facing child restraint.
Quad or Crew Cab Trucks
The top tether anchorages in this vehicle are tether
strap loops located between the rear glass and the
back of the rear seat. There is a tether strap loop
located behind each seating position. Follow the
steps below to attach the tether strap of the child
restraint.
Right Or Left Outboard Seats:
1. Raise the head restraint and reach between
the rear seat and rear glass to access the
tether strap loop.
Head Restraint In Raised Position
Tether Strap Loop With Center Head Restraint In Raised
Position
SAFETY
161
4
Advertisement
Table of Contents
