Table of Contents
Advertisement
116
GETTING TO KNOW YOUR INSTRUMENT PANEL
Stop/Start Active Indicator Light —
If Equipped
This indicator light will illuminate when
the Stop/Start function is in "Autostop"
mode.
W
I
L
HITE
NDICATOR
IGHTS
Cruise Control Ready Indicator
This indicator light will illuminate when
the Speed Control is ready, but not set.
Refer to "Speed Control" in "Starting
And Operating" for further information.
Speed Control SET Indicator Light —
If Equipped With 3.5 Inch Instrument
Cluster Display
This light will turn on when the speed
control is set.
Refer to "Speed Control" in "Starting
And Operating" for further information.
B
I
L
LUE
NDICATOR
IGHTS
High Beam Indicator Light
This indicator light will illuminate to
indicate that the high beam headlights
are on. With the low beams activated,
push the multifunction lever forward
(toward the front of the vehicle) to turn on the high
beams. Pull the multifunction lever rearward
(toward the rear of the vehicle) to turn off the high
beams. If the high beams are off, pull the lever
toward you for a temporary high beam on, "flash to
pass" scenario.
ONBOARD DIAGNOSTIC SYSTEM — OBD II
Your vehicle is equipped with a sophisticated
Onboard Diagnostic system called OBD II. This
system monitors the performance of the
emissions, engine, and transmission control
systems. When these systems are operating
properly, your vehicle will provide excellent
performance and fuel economy, as well as engine
emissions well within current government
regulations.
If any of these systems require service, the OBD II
system will turn on the Malfunction Indicator Light
(MIL). It will also store diagnostic codes and other
information to assist your service technician in
making repairs. Although your vehicle will usually
be drivable and not need towing, see an authorized
dealer for service as soon as possible.
CAUTION!
Prolonged driving with the MIL on could cause
further damage to the emission control
system. It could also affect fuel economy and
driveability. The vehicle must be serviced
before any emissions tests can be performed.
If the MIL is flashing while the vehicle is
running, severe catalytic converter damage
and power loss will soon occur. Immediate
service is required.
O
D
S
NBOARD
IAGNOSTIC
YSTEM
(OBD II) C
YBERSECURITY
Your vehicle is required to have an Onboard
Diagnostic system (OBD II) and a connection port
to allow access to information related to the
performance of your emissions controls.
Authorized service technicians may need to access
this information to assist with the diagnosis and
service of your vehicle and emissions system.
Advertisement
Table of Contents
