Memory Problems; Solving Network Problems - Compaq LTE Elite Maintenance And Service Manual

keypad on
computer keyboard
is disabled.
---------------------------------------------------------------------------
Embedded numeric
keypad is
disabled and Num
Lock function is
on.
---------------------------------------------------------------------------
External keyboard
does not work.
===========================================================================
Table 2-23. Memory Problems
===========================================================================
Problem
===========================================================================
Memory count
during Power-On
Self-Test (POST)
is incorrect.
---------------------------------------------------------------------------
"Out of Memory"
message is
displayed on the
screen, or
insufficient
memory error
occurs during
operation.
---------------------------------------------------------------------------
* TSRs (Terminate Stay Resident) are software routines that stay in RAM
memory even when not actively in use.
===========================================================================

Solving Network Problems

This section contains guidelines for troubleshooting common Ethernet
network problems. These guidelines are intended for use when you have
determined that the computer in the Compaq SmartStation is not
communicating with the network. These guidelines do not discuss the process
of troubleshooting the network cable.
The following are common problems to check first:
turned on.
External numeric keypad
is connected to the
computer.
External keyboard is not
securely connected or is
connected to an
incorrect external
connector.
Probable Cause
Optional memory card is
installed incorrectly,
is incompatible with
the computer, or is
configured incorrectly.
Too many TSRs * are
installed.
-------------------------------------------------------
Memory configuration is
not set up correctly.
-------------------------------------------------------
System ran out of memory
for the application.
enable the Num Lock function
and embedded numeric keypad.
Disconnect the external
numeric keypad from the
computer.
Ensure that the external
keyboard is securely
connected to the appropriate
external connector.
Solution(s)
1. Ensure that the
appropriate memory card
has been installed
correctly.
2. Run Computer Setup.
Delete any TSR applications
that are not needed.
Reconfigure the memory using
MS-DOS MEMMAKER.
1. Check the application
documentation for memory
requirements.
2. Install additional
memory.