Power Problems - Compaq LTE Elite Maintenance And Service Manual

PCMCIA network
card does not
work.
===========================================================================
Problem
===========================================================================
Storage card does
not work.
===========================================================================
Table 2-26. Power Problems *
===========================================================================
Problem
Network driver is not
set up properly.
Probable Cause
SRAM and flash memory
cards require the memory
card driver to be
loaded.
-------------------------------------------------------
Flash memory cards
require the Microsoft
FlashFile System to be
loaded.
-------------------------------------------------------
Hard disks on flash mass
storage cards require
the PCMCIA ATA driver to
be loaded.
-------------------------------------------------------
You are trying to access
the card using the wrong
drive letter.
-------------------------------------------------------
The card is not
formatted.
-------------------------------------------------------
The card is not
supported.
Probable Cause
Select Computer Setup from
the Compaq Control Center
and select the PCMCIA
option; then view the online
help for detailed
instructions on setting up
PCMCIA network cards.
Solution(s)
Select Computer Setup from
the Compaq Control Center;
then select the PCMCIA
option to enable the memory
card driver.
Select Computer Setup from
the Compaq Control Center;
then select the PCMCIA
option to enable the flash
file system.
Select Computer Setup from
the Compaq Control Center;
then select the PCMCIA
option to enable the PCMCIA
ATA driver.
From MS-DOS: Run CARDINFO to
determine which drive letter
is assigned to the card.
From Windows: Select
Computer Setup from the
Compaq Control Center to see
which drive letter is
assigned to the card.
From MS-DOS: For memory
cards, run MEMCARD to format
the card. For hard drive
cards and flash mass storage
cards, run ATACARD, then run
FORMAT.
From Windows: Select
Computer Setup from the
Compaq Control Center, then
select MEMCARD or ATACARD
from the PCMCIA option.
Contact Compaq Reseller
Support for a list of PCMCIA
cards tested successfully in
Compaq PCMCIA platforms.
Solution(s)