Removing The Display Assembly - Compaq LTE Elite Maintenance And Service Manual

parts compatibility, the spare display panel, inverter board, display
cable, and display enclosure for the 9.5-inch color TFT model come
preinstalled in the display assembly. To replace these parts, replace the
entire display assembly (color TFT model only).
If required, the trackball board may be replaced separately on the color
TFT model.

Removing the Display Assembly

To remove the display assembly, complete the following steps:
1. Remove the keyboard cover (Section 4.7).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
The display cable and its ZIF connector on the system board can be easily
damaged. Do not pull or twist on the cable while it is connected. To avoid
bending the small posts inside the slide, release each corner of the
connector slide with the connector removal tool using constant light force.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
2. Using the connector removal tool (Table 3-13), release the ZIF connector
slide by applying a constant light force on each corner of the connector
slide [1] [2] (Figure 4-8).
3. Remove the cable [3] (Figure 4-8).