Compaq LTE Elite Maintenance And Service Manual page 296

buttons are not interchangeable. The switch components are available in the
Miscellaneous Small Mechanical Parts Kit (Table 8-8).
NOTE: The power and eject switch boards are integrated into the power and
eject switch cable harnesses. To replace the switch boards, the cable
harnesses must be replaced (Section 9.17).
To remove the switch components, complete the following steps:
1. Remove the power switch by completing steps 1 through 5 as listed in
"Power Switch Cable Harness" in Section 9.17.
2. Remove the eject switch by completing steps 1 through 5 as listed in
"Eject Switch Cable Harness" in Section 9.17.
3. Remove the clear plastic light pipe(s) by sliding them out of the
switch.
NOTE: The power switch has two light pipes and the eject switch has one.
IMPORTANT: When replacing the light pipe(s), be sure that the textured
ends are facing out.
4. Simultaneously press the two release buttons on the switch and remove
the switch button and spring (Figure 9-51).