Compaq LTE Elite Maintenance And Service Manual page 364

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
To avoid damage to the PCMCIA connector when docking, be sure to remove any
PCMCIA cards and cables that do not allow the PCMCIA compartment door to
close fully.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
5. Remove any cable or card that does not allow the PCMCIA compartment
door to fully close.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
To avoid data loss from a computer reboot, turn the computer off before
docking it in the expansion base. Do not initiate Standby or Hibernation
before docking.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
6. Turn the computer off.
7. If the monitor support cover is being used, close the computer display.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
To avoid damage to the external options connector on the expansion base or
the external options door on the computer, be sure that the external
options door is fully open before docking.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
8. Fully slide open the external options door (Figure D-2).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
Do not press on the top edge of the display when docking the computer, as
this may cause damage to the display hinges.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
9. Place the computer into the docking bay of the expansion base and apply
even pressure below the front edge of the display (Figure D-12) to seat
the 198-pin external options connector.