Docking Mechansim Removal And Replacement - Compaq LTE Elite Maintenance And Service Manual

9.12 Docking Mechansim
NOTE:Do not lubricate the docking mechanism. To ensure freedom of movement
in the docking mechanism sled, manually move the sled when a computer
is not docked.
To remove the docking mechanism, complete the following steps:
1. Remove the bottom cover (Section 9.6).
2. Remove any expansion boards that are installed (Section 9.8).
3. Remove the expansion board cage (Section 9.9).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
The terminals on the docking mechanism motor and computer status sensor are
fragile. To avoid damaging the terminals, handle the cables carefully when
removing and replacing them.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
4. Disconnect the two cables from the docking mechanism motor (Figure 9-17).