Compaq Smartstation Removal And Replacement List; Tools Required - Compaq LTE Elite Maintenance And Service Manual

Screws
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
Screws in the unit are not interchangeable. Damage may occur if you insert
an incorrect screw. As you remove screws, place them with the component you
removed to help avoid error.
To avoid stripping out plastic or metal parts, do not over tighten plastite
or taptite screws.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
Plastics
Use care when handling the plastic case and battery charging compartment,
since they can be damaged from excessive force during removal and
replacement procedures.
Liners
The metal liners attached to the inside of the expansion enclosure are for
shielding purposes.
replacement procedures.
contact with the adjacent liners when replacing the bottom cover on the
unit.
Power Cord
The expansion base uses a three-prong grounded power cord that should be
connected to a grounded external outlet for safe operation.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> WARNING <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
The expansion base is designed for connection to a grounded (earthed)
electrical outlet. The grounding type plug is an important safety feature.
To avoid the risk of electric shock or damage to the equipment, do not
disable this feature.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

9.2 Tools Required

The following tools are required to service the expansion base:
o Flat-bladed screwdriver
o Torx T-8 screwdriver
o Torx T-10 screwdriver
o Torx T-15 screwdriver
o 3/16-inch nut driver (for screwlocks)
NOTE: Most of the screws in the expansion base are slotted Torx T-10 type,
which can be removed and replaced with a Torx T-10 or flat-bladed
screwdriver.
9.3 Removal And Replacement List
Be careful not to damage the liners during removal and
Be sure that the fingers of the liners make good