Compaq LTE Elite Maintenance And Service Manual page 131

centered on the drive so that it does not protrude over the
plastic ribs of the battery bay or the hard drive bay and
interfere with reassembly.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
To avoid damage to the drive, handle the drive by the sides. Do not handle
the drive by the top or bottom, since the drive enclosure is designed
primarily as a shield.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
4. With the cable still attached to the diskette drive, remove the drive by
lifting it up by its sides near the rear of the drive and sliding it
toward the display to release the drive button from the front of the
computer (Figure 4-25).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
The diskette drive cable and ZIF connector on the system board can be
easily damaged. Handle only the connector slide when removing or replacing
the cable; never pull or twist on the cable while it is connected to the
ZIF connector. Lift both corners of the ZIF connector slide simultaneously
with constant light force until the connector slide releases.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
5. Release the diskette drive cable ZIF connector [1] and remove the cable
[2] (Figure 4-25).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
When replacing the diskette drive cable into the ZIF connector, fully seat
the cable before closing the ZIF connector slide. Close the connector slide
by simultaneously pressing on both corners. When closed, the insertion line
on the cable should be even with the top edge of the connector slide. If it
is not, release the connector and fully seat the cable.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
6. Remove the diskette drive with its attached cable from the unit [3]
(Figure 4-25).