Removing The Keyboard - Compaq LTE Elite Maintenance And Service Manual

3. Remove the display bezel (refer to "Display Bezel" in this section).
4. Remove the display panel (refer to "Display Panel" in this section).
5. Remove the display inverter board (refer to "Inverter Board" in this
section).
6. Remove the trackball board (refer to "Trackball Board" in this
section).
7. Remove the display cable (refer to "Display Cable" in this section).
8. Remove the display latches (refer to "Display Latches" in this
section).
IMPORTANT: Before removing the screws for the clutches (step 9), note
the placement of the mounting tab for the trackball shield.
Refer to "Display Clutches" for more information.
9. Remove the display clutches (refer to "Display Clutches" in this
section).
10. Remove the trackball shield (refer to "Display Clutches" in this
section).
11. Remove the display ground cable.
The display enclosure is all that remains.
NOTE: When replacing the enclosure, install the logo that appears on the
outside. Install the logo so that it has the same orientation as the
textured logo that is part of the display enclosure. Ensure that you
use the correct logo for the appropriate computer model (Table 3-3).
4.10 Keyboard

Removing the Keyboard

To remove the keyboard, complete the following steps:
1. Remove the keyboard cover (Section 4.7).
2. Remove the two screws from the keyboard (Figure 4-22).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
To avoid damage to the keyboard cable, be careful when handling the
keyboard, since the cable is still connected. Do not pull on the cable.