Compaq LTE Elite Maintenance And Service Manual page 38

Increase
Detected
------------------------------------------------
164 - Memory 2 Short
Decrease
Detected
---------------------------------------------------------------------------
168 - CMOS None
Checksum
Invalid
---------------------------------------------------------------------------
** Autosetup configures to the default settings if you do not run Computer
Setup.
===========================================================================
Message Beeps
===========================================================================
201 - Memory None
Error
---------------------------------------------------------------------------
203 - Memory None
Address Error
memory incorrect.
Configuration
memory incorrect.
Auxiliary battery
charge is low.
Probable Cause
RAM failure.
RAM failure.
apply to both 164 error
codes:
1. Autosetup will
correct.
2. Verify that memory
board is installed
correctly.
3. Replace memory
board.
4. Replace system board.
1. Recharge auxiliary
battery. (Refer to
"Auxiliary Battery"
in Section 1.6). Run
Computer Setup if
configuration
settings are other
than default. **
Recommended Action
1. Make sure the memory
module is installed
correctly.
2. Clean the contacts of
the memory module and
system board.
3. Make sure PCMCIA
memory card is
installed correctly
by running PCMCIA
card service
software and
Computer Setup.
4. If using ISA
expansion memory
module, make sure
module is installed
correctly.
5. Replace the memory
module(s) (if
applicable).
6. Replace PCMCIA memory
card.
7. Replace ISA memory
board.
8. Replace system board.
Refer to recommended
actions for Error Code
201.