CYBEX 625C Owner's Manual page 38

2.
Press to enter the menu.
3.
Press or
Figure 2: ATSC Monitor
4.
Press or
a) Analog Only (Default): TV searches for analog channels only.
b) Digital Only: TV searches for digital channels only.
c) Analog and Digital: TV searches for both analog and digital channels.
5.
Press to select Channel Sequence.
6.
Press or
a) Interleave A+D: In the order of channel number regardless of the system.
b) All A then D: Digital channels are displayed after all analog channels.
7.
Press or
Not available when Mode is set to Analog Only.
8.
Press or
Choices are: None, Air, Cable STD, Cable IRC, or Cable HRC.
9.
Press to select Channel Map.
Cybex 625C/625R Cycle Part Number LT-23688-4 F
to select Mode.
to set the scope of channel scanning.
to set the Channel Sequence in which the channels are displayed after searching.
to select Additional Digital Signal.
to choose the Additional Digital Signal source.
Additional Digital Signal
Page 38 of 80
Mode
Channel Sequence
Channel Map