CYBEX 625C Owner's Manual page 31

7 Volume keys
8 Display option key
9 Headphone jack
10 STOP key
11 Setup key
12 Enter key
13 Up/Down keys
A/V setup mode
1. Plug the optional power cord into a power outlet from a grounded circuit, See Electrical Requirements.
Coil up the remainder of the power cord and place it out of the way. If you do not have the optional
power supply, skip to step 3.
2. Verify the control panel will illuminate and is in Dormant Mode.
3. Hold the handrails to steady self while stepping into the pedals.
4. Begin pedaling.
5.
Press and hold SCAN
Display will show clock icon.
6.
Press Down
7. Press Enter to enter setup mode.
8.
Press the Up
Adapter Box for Broadcast Vision). If C.A.B. is selected, no further setup is required.
9. Plug in headphones to listen for channels during setup.
Setup UHF Transmitters
For transmitter types 900 MHz, 863 MHz or 806 MHz. Use this procedure to associate channel numbers
to your TV transmitters. If using an FM transmitter system, skip to Setup TV FM Transmitters.
Pick transmitter type
1. Enter A/V setup mode.
2.
Select UHF and press the ENTER
3.
Press the ENTER
Cybex 625C/625R Cycle Part Number LT-23688-4 F
Increase or decrease volume
Scans for available TV transmitters, or will seek the next strongest
FM station or FM transmitter frequency.
Plug in headphones to listen to channels
Stores and exits setup
When storing FM presets, this button will clear all stored FM radio
presets. Toggles near/far for UHF receiver sensitivity.
Enters menu, accepts value shown, moves forward in menu.
Navigates TV channels or manually tunes FM frequencies
and Up
to navigate to the A/V screen.
or Down keys to change A/V type from none to UHF, FM, or C.A.B. (Console
key again to change transmitter type.
for 3 seconds.
key.
Page 31 of 80