CYBEX 625C Owner's Manual page 18

6. Route cables through gray clip on controller.
7. Plug the display cable into the display cable connector on the lower control board.
Ensure the cable connector is securely fastened.
8. Connect the console cable's DIN connector to the power supply output.
Make sure the two connectors snap firmly together and can not be pulled apart without pulling the
sleeve back to release it.
Install front covers
1. Install front left cover with one screw using a Phillips screwdriver.
2. Route optional A/V cables through front covers to front of unit.
Do not pinch or damage the cables during assembly.
In addition to the mounting screws, there are four plastic connectors that secure the front covers
together. Ensure that all four plastic connectors are inserted properly in each front cover.
3. Install front right cover with one screw using a Phillips screwdriver.
Cybex 625C/625R Cycle Part Number LT-23688-4 F
Page 18 of 80
Description
1 Display cable
2 Display cable connector
3 Gray clip
4 Power supply output
5 Console cable DIN connector
6 A/V cables, optional
7 Power cord
Description
1 Plastic Connectors
2 Screw
3 Front Left Cover
4 Optional A/V Cables
5 Front Right Cover
Qty.
1
1
1
1
1
1
1
Qty.
1
1
1
1
1