CYBEX 625C Owner's Manual page 32

4. Press Quick Start to select your transmitter type from the available choices. The display will only
show choices available under your transmitter type (900 MHz, 863 MHz or 806 MHz).
900 MHz System
M 900 MYE
C 900 Cardio Theater
E 900 Enercise
B 900 Broadcast Vision
5.
Press SCAN
display CH 1 of #. The # symbol is total number of strong UHF channels found. Some of these
channels may not be signals from the TV transmitters and need to be deleted.
Review channels
1.
Press Up or Down
2.
Delete unwanted channels by pressing Resistance Up
window to [dEL].
Press Enter to delete channel. Repeat process for additional unwanted channels.
3. Adjust the near/far setting if available channels are not showing.
Press Setup key to change the setting from F (Far) to n (Near). Press Display option
for available channels.
4.
Press Up or Down
If all TV transmitters are stored, and they all correlate the TV number to the correct TV heard, setup
is complete. If not you may need to re-scan or adjust the transmitter codes (see documentation for
your transmitters to perform a code change).
5. Press STOP to exit setup. Transmitter setup complete.
6. Proceed to Add FM Radio Stations (optional).
Setup TV FM Transmitters
If your TV's use FM transmitters, follow these instructions to assign a TV channel to each frequency.
1.
Press and the hold the Display option
Display will show time setup.
2.
Press DOWN
3.
Select TV FM and press the ENTER
Cybex 625C/625R Cycle Part Number LT-23688-4 F
863 MHz System
M 863 MYE
E 863 Enercise
A 863 Audeon
to scan for available channels. The scan can take up to 10 seconds and then
to listen to available channels with the headphones.
to scroll through and verify all TV channels.
to navigate to the A/V setup screen.
or Down
and UP keys for 3 seconds.
key.
Page 32 of 80
806 MHz System
J1 806 Japan 14 channels
J2 806 Japan 30 channels
to change the right LED
to re-scan