Installation Of Windows Nt4 Sp3 And Hp Software Components - HP Vectra VEC 7 Maintenance Manual

NOTE
5 Remove the hard disk drive from the Slave connector. Put this hard
disk drive back into the second HP Vectra VE PC.
6 Restart the PC.
7 Start the Setup program (press
and set the drive that is on the Master connector on the Primary IDE
cable as the boot device.
8 Install the operating system and HP-specific software (see below).

Installation of Windows NT4 SP3 and HP Software Components

These instructions presume that your HP Vectra VE has a bootable
hard disk drive with at least the following directories:
i386
LANDRV
MASTERS
You should be able to download any drivers, etc. that you need from the
HP Web site (
http://www.hp.com/go/vectrasupport
downloading, you can create an IDE and VIDEO directory in the
MASTERS directory and copy the installation files to the respective
directories. Follow the instructions in the readme files supplied with the
IDE and the VIDEO drivers.
Installation of NT 4 and Service Pack 3
This section explains how to install Windows NT 4.0 Workstation and
Service Pack 3 manually on an HP Vectra VE PC. We recommend that
you install NT 4.0 in two stages:
First, a basic installation using the generic system drivers supplied
•
with Windows NT 4.0, without network installation.
Second, after NT 4.0 Workstation is up and running, install the HP
•
drivers to obtain full functionality, stability and performance for the
hard disk(s), network and video.
while
F2 Setup
Contains Windows NT4. From this directory
you can reinstall NT4 and Service Pack 3.
Contains the LAN drivers package.
Contains the master versions of the HP
software.
4 Troubleshooting Your PC
Recovering Hard Disk Contents
is displayed),
). After
English 77