FIC KT-400A Manual page 20

NOTE: Users that want to use IR port must adjust BIOS feature
UART Mode Select to set COM2 at some IR mode upon your IR
device.
(1) Reset Switch is connected to the reset button. Push this switch to reboot
the system instead of turning the power button off and on.
(2) HDD LED is connected to the IDE device indicator. This LED will blink
when the hard disk drives are activated.
(3) Power (Single and Dual) /Sleep LED
Please refer to the tables below for the representations of LED states.
There is another 3-Pin Power LED connector on board for some cases that with
a 3-pin plug.
(4) Power Button is connected with power button. Push this switch allows the
system to be turned on and off rather than using the power supply button.
Installation Procedures
2 - 11