Advertisement
Quick Links
The motherboard has several user-adjustable jumpers on the board that allow
you to configure your system to suit your requirements. To set up your
computer, you should follow these installation steps To set up your computer,
you should follow these installation steps:
n
Step 1 -
Set system jumpers
n
Step 2 -
Install memory modules
n
Step 3 -
Install the CPU
n
Step 4 -
Install expansion cards
n
Step 5 -
Connect cables and power supply
n
Step 6 -
Set up BIOS feature
n
Step 7 -
Set up supporting software utilities
CAUTION : If you use an electric drill to install this motherboard on your
chassis, please wear a static wrist strap. The recommended electric drill
torque is from 5.0 to 8.0 kg/cm to avoid damaging the chips' pins.
Installation Procedures
Chapter 1
1
Advertisement
Related Manuals for FIC PA-2013
Summary of Contents for FIC PA-2013
- Page 1 Chapter 1 Installation Procedures The motherboard has several user-adjustable jumpers on the board that allow you to configure your system to suit your requirements. To set up your computer, you should follow these installation steps To set up your computer, you should follow these installation steps: Step 1 - Set system jumpers...
- Page 2 PA-2013 Motherboard Manual Clear Password: CPS This jumper allows you to enable or to disable the password configuration. You may need to enable this jumper by shorting it with a jumper cap if you forget your password. To clear the password setting: 1. Turn off your computer, (2).
- Page 3 Installation Procedures CPU to SRAM Data Transacting Mode Selection: SRAM This jumper allows you to select the CPU to SRAM data read/write mode. If you install a Cyrix or IBM processor on this motherboard, please set at 2-3 pin pair. Please also read Linear Burst feature of Chipset Features Setup, Chapter 3 for more information.
- Page 4 PA-2013 Motherboard Manual DIMM Frequency: CLK4, SDRAM System Frequency: NBCLK1, NBCLK2...
- Page 5 Installation Procedures CPU External (BUS) Frequency: CLK1, CLK2, CLK3 The table below shows the jumper settings for the different CPU speed configurations. NOTE: * when it selected, the system performance will not be guaranteed. CPU to Bus Frequency Ratio: FREQ1, FREQ2, FREQ3 These three jumpers are used in combination to decide the ratio of the internal frequency of the CPU to the bus clock.
- Page 6 Cyrix M II-300 IBM 6x86MX-PR300 3.5 x (be continued on the next page) NOTE: 1. * This type of CPU was not available for testing at time of printing. 2. For most up-to-date information, please visit the FIC web site at http://www.fic.com.tw.
- Page 7 Installation Procedures (Continued from previous page) Model Freq. Bus Freq. Ratio Cyrix/IBM 6x86MX-PR266 2.5 x Cyrix/IBM 6x86MX-PR233 2.5 x Cyrix/IBM 6x86MX-PR200 2.5 x Cyrix/IBM 6x86MX-PR166 Cyrix/IBM 6x86L-PR200+ Cyrix/IBM 6x86L-PR166+ Cyrix/IBM 6x86-PR200+ Cyrix/IBM 6x86-PR166+ IDT WinChip2-200 IDT WinChip-200 Set CPU Voltage This section lists all possible CPU voltages that this board supports.
- Page 8 PA-2013 Motherboard Manual...
- Page 9 Installation Procedures This Page Intentionally Left Blank...