FIC KT-400A Manual page 39

KT-400A /KT-600 Dynasty Mainboard Manual
VIA OnChip IDE Device
OnChip SATA (KT-600 Pro only)
This item allows you to diable the serial ATA controller embedded in South
Bridge. The options are: Enabled, Disabled.
SATA Mode (KT-600 Pro only)
This item allows users to select the serial ATA mode
The options are: IDE, Raid.
OnChip Primary/Secondary IDE
When enabled, allows you to use the onboard primary/secondary PCI IDE.
If a hard disk controller card is used, set at Disabled.
The options are: Enabled, Disabled.
IDE Prefetch Mode
When set at Enabled, it allows data to be posted to and prefetched from the
primary IDE data ports. Data prefetching is initiated when a data port read
occurs. The read prefetch eliments latency to the IDE data ports and allows
them to be performed back to back for the highest possible PIO data trans-
fer rates. The first data port read of a sector is called the demand read.
Subsequent data port reads from the sector are called prefetch reads. The
demand read and all prefetch reads must be of the same size (16 or 32 bits).
The options are: Enabled, Disabled.
Primary Master/Slave PIO
Allows an automatic or a manual configuration of the PCI primary IDE
hard drive (master/slave) mode.
Secondary Master/Slave PIO
Allows an automatic or a manual configuration of the PCI secondary IDE
hard drive (master/slave) mode.
The options are: Auto, Mode 0, Mode 1, Mode 2, Mode 3, Mode 4.
Primary Master/Slave UDMA
Allows an automatic configuration of the PCI primary IDE hard drive
(master/slave) mode if Ultra DMA is supported both on the motherboard
and the hard disk. The options are: Auto, Disabled.
3 - 12