Table of Contents
Advertisement
DIP switches 4, 5, 6: Code page tables
These switches allow you to select the following code page tables.
Character set
437 (USA)
850 (Multilingual)
850 (Multilingual)
850 (Multilingual)
850 (Multilingual)
860 (Portuguese)
863 (French Canadian)
865 Norwegian
To see samples of the character sets available with each code page table, use Canon's toll-free fax
retrieval system to request the BJC-610 Printer Command Summary.
DIP switch 7: Page length
If you are using letter-size paper, set this switch OFF; this sets the page length to 11 inches. If you are
using A4-size paper, set this switch to ON; this sets the page length to 12 inches.
DIP switch 8: Alternate Graphics Mode
Set this switch to ON to enable Alternate Graphics Mode (AGM). In this mode, the printer accepts
high-resolution, 24-dot, all-points-addressable (APA) graphics commands similar to those used with
conventional 24-pin printers.
DIP switch 9: Automatic carriage return
When this switch is OFF, the printer performs a normal line feed (LF only). Set this switch to ON if you
want the printer to perform a carriage return after each line feed (LF + CR).
1 of 1
DIP switches
4
5
6
OFF
OFF
OFF
OFF
OFF
ON
OFF
ON
OFF
ON
OFF
ON
ON
ON
OFF
ON
ON
ON
OFF
ON
ON
ON
OFF
OFF
Using the Printer With MS-DOS 239
4/15/98 2:20 PM
Advertisement
Table of Contents
